Disassembly and assembly

4 KENR6226-01
Disassembly and Assembly Section
Disassembly an
d Assembly
Section
i02959949
Fuel Filter Base - Remove and
Insta ll
(403D-11, 40
3D-15, 403D-15T,
403D-1 7, 404D-15, 404 D-22,
404D-2 2T and 404D-22TA
Engines)
Removal Procedure
NOTICE
Do not allow dirt to enter the fuel system. Thoroughly
clean the are
a around a fuel system component that
will be disconnected. Fit a suitable cover over discon-
nected fuel system component.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
NOTICE
Keep all parts clean from contaminants.
Contaminan
ts may cause rapid wear and shortened
component life.
Note: Place identification marks on all hoses for
installation purposes. Plug all hoses and all the ports
in the fuel filter base. This helps prevent fluid loss,
and this helps to keep contaminants from entering
the system.
1. Turn the fuel supply to the OFF position.
g01302737
Illustration 1
Typical example
2. Loosen hose clamps (4) and disconnect hoses (5).
3. If necessary, remove fuel filter element (7)
from fuel filter base (1). Refer to Operation
and Maintenance Manual, “Fuel System Filter -
Replace”.
4. Remove fasteners (2) and remove fuel filter base
(1) from the mounting bracket.
5. If necessary, remove plugs (6) and washers (not
shown) from fuel filter base (1). Remove tube
assemblies (3) and rubber olives (not shown) from
fuel filter base (1).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Note: If the engine is equipped with a hand priming
pump, the hand priming pump is mounted on the fuel
filter base. The assembly of the fuel filter base and
the hand priming pump is not serviceable.
1. Ensure that the fuel filter base is clean and free
from damage. If necessary, replace the fuel filter
base.
This document has been printed from SPI². Not for Resale