Disassembly and assembly

KENR6226-01 39
Disassembly and Assembly Section
g01327027
Illustration 65
Typical example
3. Install water temperature regulator (4) to water
temperature regulator housing (5). Refer to
Specifications, “Water Temperature Regulator
Housing for 403D-11, 403D-15, 403D-15T,
403D-17, 404D-15, 404D-22, 404D-22T and
404D-22TA Engines” for the correct orientation of
the water temperature regulator.
4. Install a new joint (3).
5. Install outlet connection (2) to water temperature
regulator housing (5).
Note: Ensure the correct orientation of the outlet
connection.
6. Install fasteners (1).
For 403D-11 and 404D-15 engines, tighten the
fasteners to a torque of 6 N·m (53 lb in).
For 403D-15, 403D-15T, 403D-17, 404D-22,
404D-22T and 404D-22TA engines, tighten the
fasteners to a torque of 14 N·m (124 lb in).
7. Fill the cooling system with coolant to the correct
level. Refer to Operation and Maintenance
Manual, “Cooling System Coolant -Fill” for more
information.
i02645699
Flywheel - Remove
Removal Proced
ure
Table 9
Required Tools
Tool
Part
Number
Part Description
Qty
A
-
Lifting Bracket
1
B
-
Guide Stud
(M10 x 1.25 m m by
80mm)
2
Start By:
a. Remove the electric starting motor. Refer to
Disassembly and Assembly, “Electric Starting
Motor - Remove and Install”.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Note: The two
cylinder, the three cylinder and the
four cylinder engines have different flywheels. The
removal procedure is similar for all models.
g01305297
Illustration 66
Typical example
1. Install Tooling (A) and a suitable lifting device
to flywheel (2). The weight of the flywheel is
approximately 42 kg (93 lb).
This document has been printed from SPI². Not for Resale