Disassembly and assembly

KENR6226-01 37
Disassembly and Assembly Section
Personal injury can result from parts and/or cov-
ers under spring pressure.
Spring force will be released when covers are re-
moved.
Be prepared to hold spring loaded covers a s the
bolts are loosened.
2. Remove bolts (6) and nuts (5).
3. Remove outlet connection (4).
4. Remove joint (3).
5. Remove water temperature regulator (2) and
spring (1).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Inspect the water temperature regulator for
wear, damage and correct operation. Refer
to Systems Op
eration,Testing and Adjusting,
“Water Temperature Regulator - Test” for more
information. If necessary, replace the water
temperatur
e regulator.
2. Ensure that the mating surfaces of the outlet
connection
and the cylinder head are clean and
free from damage.
g01326174
Illustration 63
Typical example
Personal injury can result from parts and/or cov-
ers under spring pressure.
Spring force will be released when c overs are re-
moved.
Be prepared to hold spring loaded covers as the
bolts are loosened.
3. Install spring (1) and water temperature regulator
(2) to the cylinder head. Ensure that jiggle pin
(7) on water temperature regulator (2) is in the
vertically upward position.
4. Install a new joint (3) to the cylinder head.
5. Position outlet connection (4) onto the cylinder
head. Install nut (5) and bolts (6) to outlet
connection (4). Tighten the fasteners to a torque
of8N·m(71lbin).
6. Fill the cooling system with coolant to the correct
level. Refer to Operation and Maintenance
Manual, “Cooling System Coolant - Fill” for more
information.
This document has been printed from SPI². Not for Resale