Disassembly and assembly
KENR6226-01 35
Disassembly and Assembly Section
g01308309
Illustration 59
Typical example
2. Install a new joint (6) to the cylinder head.
If the water pump has a spacer, install spacer (5)
and install a new joint (4) to the cylinder head.
3. Place water pump (1) in position and install
fasteners (7). Tighten the fasteners finger tight.
4. Position adjusting link (2) for the alternator on the
water pump. Install bolt (3) finger tight.
Note: On some engines, the adjusting link for the
alternator is secured by two bolts.
5. If the adjusting link for the alternator is secured
by one bolt, tighten fasteners (7) to a torque of
10 N·m (89 lb in).
If the adjusting link for the alternator is secured by
two bolts, tighten fasteners (3) and (7) to a torque
of 10 N·m (89 lb in).
6. Connect the hose (not shown) to the water pump
inlet and tighten the hose clamp.
7. Fill the cooling system with coolant. Refer to
Operation and Maintenance Manual, “Cooling
System Coolant - Fill” for the correct procedure.
End By:
a. Install the alternator. Refer to Disassembly and
Assembly, “Alternator - Remove and Install”.
b. Install the fan. Refer to Disassembly and
Assembly, “Fan - Remove and Install”.
i02645789
Water Temperature R egulator
Housing - Remove and Install
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants m
ay cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting
and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent contain
ing fluids.
Dispose of all fluids according to local regulations and
mandates.
1. Drain the coolant from the cooling system into a
suitable container for storage or disposal. Refer
to Operation
and Maintenance Manual, “Cooling
System Coolant - Drain” for more information.
g01307377
Illustration 60
Typical example
2. Loosen hose clamps (5) and disconnect hose (6)
from water te mp erature regulator housing (2).
3. Remove bolts (4) and nuts (3).
4. Remove water temperature regulator housing (2)
from the cylinder head.
5. Remove joint (1) from the cylinder head.
This document has been printed from SPI². Not for Resale