Disassembly and assembly

32 KENR6226-01
Disassembly and Assembly Section
i02960013
Water P ump - Remove and
Insta ll
(403D-11, 403D
-15, 403D-15T,
403D-1 7, 404D-15, 404 D-22,
404D-2 2T and 404D-22TA
Engines)
Removal Procedure
Start By:
a. Remove the fa
n. Refer to Disassembly and
Assembly, “Fan - Remove and Install”.
b. Remove the al
ternator. Refer to Disassembly and
Assembly, “Alternator - Remove and Install”.
NOTICE
Keep all part
s clean from contaminants.
Contaminants may cause rapid wear and shortened
component li
fe.
NOTICE
Care must be t
aken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the
fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
1. Drain the co
olant from the cooling system into a
suitable container for storage or disposal. Refer
to Operation and Maintenance Manual, “Cooling
System Coo
lant - Drain” for more information.
2. Loosen the hose clamp and disconnect the hose
(not shown
)fromthewaterpumpinlet.
g01304930
Illustration 52
Typical example
g01305206
Illustration 53
Typical example
3. Loosen hose clamps (5) and remove hose (6)
from water pump (1).
4. Remove bolt (3) and alternator bracket (2) from
water pump (1).
Note: The alternator bracket on some engines is
secured by two bolts.
5. Remove fasteners (7) and remove water pump (1).
Note: If necessary, gently tap the water pump with a
soft faced hammer in order to loosen the water pump.
6. Remove joint (4) from the cylinder block.
This document has been printed from SPI². Not for Resale