Disassembly and assembly

KENR6226-01 31
Disassembly and Assembly Section
g01305805
Illustration 49
Typical example
Improper assembly of parts that a re spring loaded
can cause bodily injury.
To prevent possible injury, follow the e stablished
assembly procedure and wear protective equip-
ment.
2. Apply Tooling (B) to the faces of inner rotor (4)
and to the vanes of idler gear (3).
3. Align timing marks (X) on idler gear (3) with the
respective timing marks on gears (19) and (20).
Install idler gear (3) onto idler hub (1).
4. Install inner rotor (4) to idler gear (3).
Personal injury can result from the release of the
spring force.
The drive shaft, the piston, a nd the drive gear are
under spring force.
Use a press to slowly release the spring force be-
fore the components are removed.
5. Install the following items to idler hub (1):
•
Oil pump cover (5)
•
Shim (6)
•
Spring (7)
•
Collar (8)
Refer to Illustration 48.
6. Install retain
ing ring (9) on idler hub (1).
g01320625
Illustration 50
Checking end play by u sing a feeler gauge
7. Use a feeler gauge in order to measure the
end play of the engine oil pump. Refer to
Specifications, “Engine Oil Pump”.
8. If the oil strainer was removed, follow Steps 8.a
through 8.c in order to install the oil strainer.
g01327023
Illustrat
ion 51
a. Install a new O-ring seal (10) on oil tube
assembly (
11).
b. Install oil suction pipe (11) in the cylinder block.
c. Install oil strainer (13) to the cylinder block
and tighten bolts (12) to a torque of 11 N·m
(97lbin)
.
End By:
a. Install the front housing. Refer to Disassembly and
Assembly, “Housing (Front) - Install”.
b. Install the engine oil pan. Refer to Disassembly
and Assembly, “Engine Oil Pan - Remove and
Install”
.
This document has been printed from SPI². Not for Resale