Disassembly and assembly

28 KENR6226-01
Disassembly and Assembly Section
Installation P
rocedure
NOTICE
Keep all parts c
lean from contaminants.
Contaminants may cause rapid wear and shortened
component life
.
g01316066
Illustration 41
Typical ex
ample
1. Install a new O-ring seal (1) to engine oil relief
valve (2).
2. Lubricate engine oil relief valve (2) with clean
engine oil
.
3. Install engine oil relief valve (2) into the cylinder
block. Ti
ghten the engine oil relief valve to a
torque of 64 N·m (47 lb ft).
i02645678
Engine Oil Pump - Remove
Removal Proced
ure
Start By:
a. Remove the front housing. Refer to Disassembly
and Assembly, “Housing (Front) - Remove”.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjustin
g and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containi
ng fluids.
Dispose of all fluids according to local regulations and
mandates.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
If the front housing is not installed, do not turn the
crankshaft. Damage to the engine may occur.
Engine Oil Pump
g01304840
Illustration 42
This document has been printed from SPI². Not for Resale