Disassembly and assembly

KENR6226-01 27
Disassembly and Assembly Section
Note: Make a temporary mark in order to show the
orientation of
the oil cooler for installation.
6. Remove O-ring seal (6) from oil cooler (3).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that the oil cooler is clean and free from
damage. Clean the mating surfaces of the cylinder
block.
g01304837
Illustration 39
Typical example
2. Install a new O-ring seal (6) to oil cooler (3).
Position oil cooler (3) on the cylinder block and
install adapter (4). Tighten adapter (4) to a torque
of 34 N·m (25 lb ft).
Note: Ensure that the oil cooler is correctly oriented.
3. Connect hoses (1) to the coolant inlet and the
coolant outlet on oil cooler (3). Tighten hose
clamps (2).
4. Install a new oil filter element (5).
5. Fill the cooling system to the correct level. Refer
to Operation and Maintenance Manual, “Cooling
System Coolant - Fill” for the correct procedure.
6. Fill the engine oil pan to the correct level. Refer to
Operation and Maintenance Manual, “Engine Oil
Filter - Change” for the correct procedure.
i02645679
Engine O il Re lief Valve -
Remove and Ins tall
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants m
ay cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting
and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent contain
ing fluids.
Dispose of all fluids according to local regulations and
mandates.
g01316066
Illustration 40
Typical example
1. Remove engine oil relief valve (2) from the cylinder
block.
2. Remove O-ring seal (1) f rom engine oil relief valve
(2).
This document has been printed from SPI². Not for Resale