Disassembly and assembly

KENR6226-01 25
Disassembly and Assembly Section
g01304820
Illustrat
ion 34
Typical example
1. Loosen nut (2) that attaches the clip on oil line (1)
to the fuel injection pump.
2. Remove banjo bolt (3) and remove washers (4)
from the cylinder block.
g01307372
Illustration 35
Typical example
3. Remove banjo bolt (5) and remove washers (6)
from the cylinder head.
4. Remove oil line (1) from the engine.
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01304820
Illustrat
ion 36
Typical example
1. Place oil line (1) on the engine. Ensure that the
clip on the oil line is located below nut (2).
2. Position banjo bolt (3) and new washers (4) onto
oil line (1). Install the banjo bolt and oil line to the
cylinder
block finger tight.
This document has been printed from SPI². Not for Resale