Disassembly and assembly

24 KENR6226-01
Disassembly and Assembly Section
4. Install valve spring (3) to the cylinder head.
Position valve
spring retainer (2) onto valve spring
(3).
Personal injury can result from being struck by
parts propel
led by a released spring force.
Make sure to wear all necessary protective equip-
ment.
Follow the recommended procedure and use all
recommended
tooling to release the spring force.
NOTICE
Ensure that the valve spring is compressed squarely
or damage to the valve stem may occur.
g01315963
Illustration 33
Typical example
5. Use Tooling (A) in order to compress valve spring
(3). Install valve keepers (1).
Note: Donotcompressthespringsothatvalve
spring retainer (2) touches valve stem seal (4).
The v alve spring keepers can be thrown from
the valve when the valve spring compressor is
released. Ensure that the valve spring keepers
are properly installed on t he valve stem. To help
prevent personal injury, keep away from the front
of the valve spring keepers and valve springs
during the installation of the valves.
6. Remove Tooling (A).
7. Repeat Steps 4 to 6 for the remaining valves.
8. Place the cylin
der head on a suitable support.
Ensure that the heads of the valves are not
obstructed. Gently strike the top of the valves
with a soft ham
mer in order to ensure that valve
keepers (1) are properly installed.
End By:
a. Install the cylinder head. Refer to Disassembly
and Assembly
, “Cylinder Head - Install”.
i02959976
Engine Oil Line - Rem ove and
Install
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
This document has been printed from SPI². Not for Resale