Disassembly and assembly

KENR6226-01 15
Disassembly and Assembly Section
End By:
a. Install the fuel shutoff solenoid. Refer to
Disassembly and Assembly, “Fuel Shutoff
Solenoid - Rem
ove and Install”.
i02959963
Fuel Injector
- Rem ove and
Insta ll
Removal Proce
dure
Start By:
a. Remove the fuel injection lines. Refer to
Disassembly and Assembly, “Fuel Injection Lines
- Remove and I
nstall”.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusti
ng and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent contai
ning fluids.
Dispose of all fluids according to local regulations and
mandates.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01320610
Illustration 19
Typical example
1. Use a deep socket to remove fuel injector (1) from
the cylinder he
ad.
2. Remove seat washers (2) from the cylinder head.
Note: 402D-05 and 403D-07 engines have two seat
washers. The seat washers are different diameters.
The 403D-11, 4
03D-15, 403D-15T, 403D-17,
404D-15, 404D-22, 404D-22T and 404D-22TA
engines have one seat washer.
3. Cap all openings or plug all openings immediately.
Installation Procedure
Table 2
Required Tools
Tool
Part
Number
Part Description Qty
A
1861117
POWERPART
Universal Jointing
Compound
1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01304054
Illustration 20
Typical ex
ample
1. Clean the bore for the fuel injector in the cylinder
head. Ensu
re that no debris enters the cylinder.
Clean the threads on the body of the fuel injector.
2. Install n
ew seat washers (2) into the bore for the
fuel injector in the cylinder head.
This document has been printed from SPI². Not for Resale