Disassembly and assembly

12 KENR6226-01
Disassembly and Assembly Section
For 403D-11, 403D-15, 403D-15T, 403D-17,
404D-15, 404D-
22, 404D-22T and 404D-22TA
engines, tighten the union nuts (1) to a torque of
23 N·m (17 lb ft).
9. Turn the fuel supply to the ON position.
10. Prime the fuel
system. Refer to Operation and
Maintenance Manual, “Fuel System - Prime” for
more information.
i02645718
Fuel Shutoff Solenoid -
Remove and In
stall
Removal Procedure
NOTICE
Care must be taken to ensure that fluids are contained
during perfo
rmance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compa
rtment or disassembling any compo-
nent containing fluids.
Dispose of a
ll fluids according to local regulations and
mandates.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Turn the battery disconnect switch to the OFF
position.
g01326564
Illustration 13
Typical e
xample
2. Disconnect electrical connection (3) from
the harness ass
embly (not shown). Mark all
connections for installation.
3. Remove fuel sh
utoff solenoid (1) from the fuel
injection pump housing by rotating the fuel shutof f
solenoid in a counterclockwise direction.
4. Remove sealing washer (2) from fuel shutoff
solenoid (1).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01326564
Illustration 14
Typical example
1. Install sealing washer (2) to fuel shutoff solenoid
(1).
2. Install fuel shutoff solenoid (1) into the fuel
injection pump housing by rotating the fuel shutof f
solenoid in a clockwise direction. Tighten the fuel
shutoff solenoid to a torque of 17 N·m (12 lb ft).
3. Connect electrical connection (3) to the harness
assembly (not shown).
4. Turn the battery disconnect switch to the ON
position.
This document has been printed from SPI². Not for Resale