Disassembly and assembly

102 KENR6226-01
Disassembly and Assembly Section
i02645769
Elec tric Startin g Moto r -
Remove and Install
Removal Procedure
Accidental en
gine starting can cause injury or
death to pe rsonnel working on the equipment.
To avoid accid
ental engine starting, disconnect
the battery cable from the negative (−) battery ter-
minal. Completely tape all metal surfaces of the
disconnecte
d battery cable end in order to prevent
contact with other metal s urfaces which could ac-
tivate the engine electrical system.
Place a Do Not Operate tag at the Start/Stop switch
location to inform personnel that the equipment is
being worke
d on.
1. Disconnect the battery.
2. Make temporary identification marks on the
harness assemblies that are connected to the
electric st
arting motor.
g01326136
Illustration 192
Typical example
3. Disconnect the harness assemblies (not shown)
from electric starting motor (2).
4. Remove fasteners (1) that secure electric starting
motor (2).
Note: Support the weight of the electric starting
motor as the fasteners are removed.
5. Remove electric starting motor (2) from the
engine.
Installation P
rocedure
g01326136
Illustration 193
Typical example
1. Install electric s tarting motor (2) in position on the
engine.
2. Install fasteners (1) and tighten to a torque of
50 N·m (37 lb ft).
3. Connect the harness assemblies (not shown) to
electric starting motor (2).
4. Connect the battery.
This document has been printed from SPI². Not for Resale