Disassembly and assembly

KENR6226-01 101
Disassembly and Assembly Section
i02645650
Altern ato r - Remove and Insta ll
(14Ampand15Amp
Alternators)
Removal Procedure
Start By:
a. Remove the V-B
elt. Refer to Disassembly and
Assembly, “V-Belts - Remove and Install”.
NOTICE
Keep all parts
clean from contaminants.
Contaminants may cause rapid wear and shortened
component lif
e.
1. Turn the battery disconnect switch to the OFF
position.
2. Make temporary identification marks on the
connections of the harness assembly.
g01308275
Illustration 190
Typical example
3. Disconnect the harness assembly (not shown)
from alternator (6).
4. Remove bolt (1), washer (3) and nut (4) from
alternator (6).
5. Remove bolt (7) and remove alternator (6) from
the engine.
6. If necessary, remove bolts (5) and remove
adjusting link
(2).
Note: The adjusting link on some engines is secured
by one bolt.
Installation
Procedure
g01308275
Illustration 191
Typical example
1. If necessary, install adjusting link (2) and install
bolts (5) finger tight.
Note: The adjusting link on some engines is secured
by one bolt.
2. For engines that have an adjusting link that is
secured by one bolt, leave bolt (5) loose.
For engines that have an adjusting link that is
secured by two bolts, tighten bolts (5) to a torque
of 10 N·m (89 lb in).
3. Position alternator (6) on the engine and install
bolt (7) finger tight.
4. Install bolt (1), washer (3) and nut (4) finger tight.
5. Install the V-Belt. Refer to Disassembly and
Assembly, “V-Belts - Remove and Install”.
Note: Ensure that the alternator pulley is in alignment
with the crankshaft pulley. Ensure that all fasteners
are tightened.
6. Connect the harness assembly (not shown) to the
alternator.
7. Turn the battery disconnect switch to the ON
position.
This document has been printed from SPI². Not for Resale