Disassembly and assembly

100 KENR6226-01
Disassembly and Assembly Section
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Turn the battery disconnect switch to the OFF
position.
2. Make temporary identification marks on the
connections of the harness assembly.
g01308278
Illustration 188
Typical example
3. Disconnect the harness assembly (not shown)
from alternator (4).
4. Remove bolt (5), washer (6) and spacer (3) from
alternator (4).
5. Remove bolt (8) and washer (7). Remove the
alternator (4) from the mounting bracket.
6. If necessary, remove bolts (1) and remove
adjusting link (2).
Installation P
rocedure
g01308278
Illustration 189
Typical example
1. If necessary, install adjusting link (2) and install
bolts (1). Tighten bolts (1) to a torque of 10 N·m
(89 lb in).
2. Position alternator (4) on the mounting bracket
and install bolt (8) and washer (7) finger tight.
3. Install bolt (5), washer (6) and spacer (3) finger
tight.
4. Install the V-Belt. Refer to Disassembly and
Assembly, “V-Belts - Remove and Install”.
Note: Ensure that the alternator pulley is in alignment
with the crankshaft pulley. Ensure that all fasteners
are tightened.
5. Connect the harness assembly (not shown) to the
alternator.
6. Turn the battery disconnect switch to the ON
position.
This document has been printed from SPI². Not for Resale