User Manual

Heater Connections for Operators

Enclosure for 854F-E34T Engines

If heaters are supplied by the engine manufacturer,

tighten the bolts to a torque of 40 ± 4 N·m

(30 ± 3 lb ft).

Heater Connection for Crankcase

Breather for 854F-E34T Engines

Illustration 105 g03240717

Typical example

1. Install clamp (5) to pipe (6).

2. Install heater connection (4) to pipe (6).

3. Install hose connector (3) to heater connection (4).

4. Install clamp (2) to hose (1).

5. Install hose (1) to hose connector (3).

6. Tighten the clamps (2) and (5) to a torque of

5 ± 1 N·m (44 ± 9 lb in).

Auxiliary Crankshaft Pulley for

854F-E34T Engines

NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened

component life.

1. Ensure that all components are clean and free from

wear and damage. If necessary, replace any

components that are free from wear and damage.

Illustration 106 g02926996

2. Install crankshaft multi V-pulley (3) onto the

crankshaft.

3. Install crankshaft V-pulley (2).

4. Install bolts (1) to the crankshaft pulley. Tighten the

bolts to a torque of 45 ± 4.5 N·m (33 ± 3 lb ft)

Note: Use a suitable method to prevent the

crankshaft from rotating when torquing the bolts.

Hydraulic Pump Drive Adaptor for

854F-E34T Engines

Table 17

Required Tools

Tool Part Number

Part Description Qty

Delphi Lockheed Compound

Rubber Grease

This document has been printed from SPI2. NOT FOR RESALE