User Manual

51
Engine Labels for 854F-E34T
Engines
All engines are supplied with a loose right-hand side
universal warning label for customer installation.
The total number of labels supplied with an engine
may include:
• Right-hand side universal warning label
• Oil type label for the oil filler cap
• Valve mechanism cover branding plate
• Duplicate emission label
Note: All universal warning labels (where not
installed) must be placed in a visible location on or
close to the engine.
Note: All other labels must be installed in the
designated locations.
Note: A duplicate emissions label is supplied loose
with the engine if a written request has been
submitted.
The emission labels installed to the engine have a
clear top masking film. This masking film does not
always perform well in the customer paint process.
The customer may wish to paint over the installed
emissions label with the intention of installing the
duplicate label in the same location. The film on the
label installed to the engine must be removed prior to
the engine being painted by the customer. When the
duplicate label is applied, full tamperproof properties
are achieved.
Engine Lubricating Oil
Recommendations
NOTICE
Perkins require the use of the following specification
of engine oil. Failure to use the appropriate specifica-
tion of engine oil will reduce the life of your engine.
Failure to use the correct specification of engine will
also reduce the life and the effectiveness of your
aftertreatment system.
Table 16
API Classifications for the Industrial Engine
Oil Specification
ECF-3
CJ-4
AECA E9
Note: Ensure that the correct oil type label is applied
to the oil filler cap.
Coolant Recommendations
The following two coolants are used in Perkins diesel
engines:
Preferred – Perkins ELC (Extended Life Coolant).
Acceptable – A Perkins DEAC (Diesel Engine
Antifreeze/Coolant) or a commercial heavy-duty
antifreeze that meets “ASTM D6210” specifications
NOTICE
The Perkins industrial engine must be operated
with a 1:1 mixture of water and glycol. This con-
centration allows the NOx reduction system to op-
erate correctly at high ambient temperatures.
Perkins recommends a 1:1 mixture of water and
glycol. This mixture of water and glycol will provide
optimum heavy-duty performance as an antifreeze.
Ensure that the coolant fill rate meets the
recommended coolant fill rate for the application.
Glow Plug Control Unit for 854F-
E34T Engines
Illustration 104 g03350062
Typical example
Note: Ensure that the glow plug control unit is in a
vertical position.
Tighten the setscrew (1) to a torque of 8 ± 1 N·m
(71 ± 9 lb in).
Install the harness to the glow plug control unit.
This document has been printed from SPI2. NOT FOR RESALE