User Manual

49
Oxygen Sensor for 854F-E34T
Engines
Table 14
Required Tools
Tool Part Number
Part Description Qty
A
-
Bostik Pure Nickel
Anti-Seize Compound
1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 100 g02725166
1. If necessary, install a new sealing washer (4) (not
shown) to oxygen sensor (2).
2. Apply Tooling (A) to the threads of oxygen sensor
(4) (not shown).
3. Install oxygen sensor (2) to exhaust tube assembly
(3). Tighten the oxygen sensor to a torque of
50 ± 5 N·m (37 ± 4 lb ft).
4. Connect harness assembly (1).
Note: The bend radius for the harness assembly
must be more than 20 mm (0.80 inch).
Note: The bend radius for the grommet must be more
than 12 mm (0.47 inch).
Temperature Sensor (DPF) for
854F-E34T Engines
All Diesel Particulate Filters (DPFs) require Diesel
Oxidation Catalyst (DOC) inlet and outlet temperature
sensors.
All remote DPFs will have the temperature sensors
supplied loose.
Note: If the DPF is supplied assembled to engine, the
temperature sensors are pre-installed.
Illustration 101 g03237176
Typical example
(A) Inlet temperature sensor
(B) Outlet temperature sensor
For both through flow and wall flow DPFs the inlet
temperature sensors have a black electrical
connector, the outlet sensor has a white electrical
connector. Both through flow and wall flow DPFs use
the same sensors.
Table 15
Required Tools
Tool Part Number
Part Description Qty
A
-
Bostik Pure Nickel
Anti-Seize Compound
1
1. Ensure that all components are clean and free from
wear and damage. If necessary, replace any
components that are worn or damaged.
This document has been printed from SPI2. NOT FOR RESALE