User Manual

Illustration 89 g01334421

Typical example

1. Install Tooling (A) in illustration 87, as shown.

2. Set the pointer of the dial indicator to 0 mm

(0 inch).

3. Turn the flywheel. Read the dial indicator for every

45 degrees.

Note: During the check, keep the crankshaft pressed

toward the front of the engine to remove any end play.

4. Calculate the difference between the lowest

measurement and the highest measurement of the

four locations. This difference must not be greater

than 0.03 mm (0.001 inch) for every 25 mm

(1.0 inch) of the radius of the flywheel. The radius

of the flywheel is measured from the axis of the

crankshaft to the contact point of the dial indicator.

Flywheel Runout

Table 13

Required Tools

Tool

Part

Number

Part Description Qty

Dial Indicator 1

Illustration 90 g01334422

Typical example

1. Install Tooling (A) in illustration 88, as shown.

2. Set the pointer of the dial indicator to 0 mm

(0 inch).

3. Turn the flywheel. Read the dial indicator for every

45 degrees.

4. Calculate the difference between the lowest

measurement and the highest measurement of the

four locations. This difference must not be greater

than 0.30 mm (0.012 inch).

Electric Starting Motor on Certain

854F-E34T Engines

In certain instances, the customer may need to install

the electric starting motor to the engine.

Illustration 91 g02844537

Typical example

1. If necessary, position a new gasket (4) onto electric

starting motor (3).

This document has been printed from SPI2. NOT FOR RESALE