User Manual

Illustration 87 g01334421

Typical example

1. Install Tooling (A) in illustration 87, as shown.

2. Set the pointer of the dial indicator to 0 mm

(0 inch).

3. Turn the flywheel. Read the dial indicator for every

45 degrees.

Note: During the check, keep the crankshaft pressed

toward the front of the engine to remove any end play.

4. Calculate the difference between the lowest

measurement and the highest measurement of the

four locations. This difference must not be greater

than 0.03 mm (0.001 inch) for every 25 mm

(1.0 inch) of the radius of the flywheel. The radius

of the flywheel is measured from the axis of the

crankshaft to the contact point of the dial indicator.

Flywheel Runout

Table 11

Required Tools

Tool

Part

Number

Part Description Qty

Dial Indicator 1

Illustration 88 g01334422