User Manual

ManualsBrandsPerkins Engine ManualsOtherPerkins Engine 1206F-E70TA, 1206F-E70TTA, 1204F-E44TA, 1204F-E44TTA, and 854F-E34T Customer Assembly

Product Lifting for 854F-E34T Engines

Illustration 77 g02475658

Typical example

NOTICE

Never bend the eyebolts and the brackets. Only load

the eyebolts and the brackets under tension. Remem-

ber that the capacity of an eyebolt is less as the angle

between the supporting members and the object be-

comes less than 90 degrees.

When it is necessary to remove a component at an

angle, only use a link bracket that is properly rated for

the weight.

Use a hoist to remove heavy components. Use an

adjustable lifting beam to lift the engine. All

supporting members (chains and cables) should be

parallel to each other. The chains and cables should

be perpendicular to the top of the object that is being

lifted.

Some removals require lifting the fixtures to obtain

correct balance and safety.

To remove the engine ONLY, use the lifting eyes that

are on the engine.

Lifting eyes are designed and installed for specific

engine arrangements. Alterations to the lifting eyes

and/or the engine make the lifting eyes and the lifting

fixtures obsolete. If alterations are made, ensure that

correct lifting devices are provided.

Note: The engine is equipped with three lifting eyes.

All the lifting eyes must be used to lift the engine.

Engine Air Cleaner for 854F-E34T

Engines

Illustration 78 g03179402

Typical example

The engine air cleaner (1) can be supplied as a loose

assembly. The engine air cleaner should be mounted

horizontally. The dust exhaust port must be at the

lowest point and positioned in a downward direction.

Note: Do not paint the dust exhaust port. Solvents

and chemicals will shorten the usable life of the

exhaust port.

Note: There are several variations of engine air

cleaner.

Select the appropriate sized fasteners for the relevant

air cleaner. Bolts should have a flanged head or be

installed with a washer under the bolt head.

Standard duty air cleaner

Tighten the M8 bolts to the following torque.

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 N·m ((16 lb ft))

This document has been printed from SPI2. NOT FOR RESALE