User Manual

Illustration 70 g03051917

Typical example

Refer to illustration 70 for the location of the lifting

eyes to lift the PETU.

Note: The weight of the PETU is approximately 18 kg

(40 lb).

Engine Only

Illustration 71 g03051679

Typical example

Refer to illustration 71 for the location of the lifting

eyes to lift the engine.

Product Lifting for 1204F-E44TA, and

1204F-E44TTA Engines

NOTICE

Never bend the eyebolts and the brackets. Only load

the eyebolts and the brackets under tension. Remem-

ber that the capacity of an eyebolt is less as the angle

between the supporting members and the object be-

comes less than 90 degrees.

When it is necessary to remove a component at an

angle, only use a link bracket that is properly rated for

the weight.

Read all the information within produce lifting before

any lifting is attempted. Ensure that the correct set of

lifting eyes for the assembly to be lifted have been

selected.

Engine and Clean Emission Module (CEM)

Illustration 72 g03674678

Typical example

The front lifting eye for engine and aftertreatment is

installed by three bolts. The design of the lifting eyes

will allow access to lift the aftertreatment and engine.

This document has been printed from SPI2. NOT FOR RESALE