User Manual

25
Illustration 54 g03179003
Typical example
Ports (9)(8), and (11) are inlet connections.
Ports (4)(5)(6), and (7) are outlet connections.
Install connectors (3) and sealing plugs (2) to the inlet
ports and outlet ports. Tighten the connectors and
sealing plugs to a torque of 17 ± 2 N·m
(150 ± 18 lb in).
Tighten water in fuel sensor (10) hand tight.
Note: If harness assembly is cable strapped, remove
cable strap from harness assembly.
Remote Engine Oil Filter Base for
1204F-E44TA, 1204F-E44TTA
Engines
On certain engines, a remote mounted engine oil filter
base may be used.
Cleanliness
• Maximum dirt level within oil filter base is 5 mg.
• Maximum dirt level within fluid handling hoses and
pipe work is 6 mg/m length.
• Maximum particle size within fluid handling hoses
and pipe work is non-rubber particle size of 125
microns maximum.
• Maximum particle size within fluid handling hoses
and pipe work is rubber particle size of 600
microns maximum.
1. Position remote mounted engine oil filter base to
the application. Install recommended M8 fasteners
to engine oil filter base. Tighten M8 fasteners to a
tightening torque of 22 N·m (195 lb in).
2. Follow Step 2.a through Step 2.c to install the
connection to the remote mounted engine oil filter
base.
Illustration 55 g03692720
Typical example
a. Install O-ring (2) to connection (3).
b. Install connection (3) to oil filter base (1).
c. Tighten connection (3) to a torque of
65 ± 10 N·m (48 ± 7 lb ft).
3. Follow Step 3.a through Step 3.d to install the
elbow to the engine oil filter base.
This document has been printed from SPI2. NOT FOR RESALE