User Manual

Illustration 52 g03725234

Typical example

1. Remove plug (4). Connect plastic tube assembly to

fuel priming pump (2).

Note: In some applications, the customer should

install a connection after plug (4) is removed. The

connection should be tightened to a torque of 20 N·m

(177 lb in).

2. Install fuel priming pump (2) to the application.

3. Connect hose assembly to the 10 mm (0.39 inch)

inlet connection (2) of the fuel priming pump.

Note: For some applications, the customer must

connect to the SAE J2044 connection (5).

4. Connect the harness assembly to fuel priming

pump connection (1).

Note: Ensure that the flow of fuel through the fuel

priming pump follows the direction as shown in

illustration 51.

Water Separator and Fuel Filter

(Primary) for 1206F-E70TA, and

1206F-E70TTA, 1204F-E44TA,

1204F-E44TTA Engines

The water separator and fuel filter (primary) (1) can

be supplied loose. The following components will be

supplied.

Illustration 53 g03178977

Typical example

• Connectors (2)

• M16 by 1.5 sealing plugs (3)

This document has been printed from SPI2. NOT FOR RESALE