User Manual

Fuel Cooler for 1206F-E70TA, and

1206F-E70TTA, 1204F-E44TA,

1204F-E44TTA Engines

The fuel cooler can be supplied loose.

Illustration 49 g03179997

Typical example

Install the fuel cooler (1) to the application.

Install the nuts (3) finger tight. Tighten the nuts to a

torque of 35 ± 5 N·m (26 ± 4 lb ft).

Note: Ensure that the 30 mm (1.18 inch) hexagonal

connection (2) is secure when the nuts (3) are

tightened.

Fuel Filter (In-Line) for 1206F-

E70TA, and 1206F-E70TTA, 1204F-

E44TA, 1204F-E44TTA Engines

The fuel filter (In line) can be supplied loose.

Illustration 50 g03178796

Typical example

The fuel filter (In line) has an inlet connection of

12.7 mm (0.5 inch) (2). The fuel filter (In line) has an

outlet connection of 10 mm (0.39 inch) (1).

Note: Ensure that the flow of fuel through the fuel

filter (In line) follows the direction as shown in

illustration 50.

Fuel Priming Pump (Electric Fuel

Lift Pump (EFLP)) for 1206F-E70TA,

and 1206F-E70TTA, 1204F-E44TA,

1204F-E44TTA Engines

The fuel priming pump can be supplied loose.

Illustration 51 g03691471

Typical example

This document has been printed from SPI2. NOT FOR RESALE