Operation and maintenance manual

SEBU8601-01 9
Safety Section
General Hazard Information
Do not wear loos
e clothing or jewelry that can snag
on controls or on other parts of the engine.
Ensure that al
l protective guards and all covers are
securedinplaceontheengine.
Never put mai
ntenance uids into glass containers.
Glass containers can break.
Use all clea
ning solutions with care.
Report all necessary repairs.
Unless other instructions are provided, perform
the maintenance under the following c onditions:
The engine is stopped. Ensure that the engine
cannot be started.
Disconnect the batteries when maintenance
is performed or when the electrical system is
serviced
. Disconnect the battery ground leads.
Tape the leads in order to help prevent sparks.
Do not att
empt any repairs that are not understood.
Use the proper tools. Replace any equipment that
is damaged or repair the equipment.
Pressurized Air and Water
Pressurized air and/or water can cause debris
and/or hot water to be blown out. This could result in
person
al injury.
When pressurized air and/or pressurized water is
used f
or cleaning, wear protective clothing, protective
shoes, and eye protection. Eye protection includes
goggles or a protective face shield.
The maximum air pressure for cleaning purposes
must be below 205 kPa (30 psi). The maximum
wate
r pressure for cleaning purposes must be below
275kPa(40psi).
Fluid Penetration
Pres
sure can be trapped in the hydraulic circuit long
after the engine has been stopped. The pressure can
cause hydraulic uid or items such as pipe plugs to
esc
ape rapidly if the pressure is not relieved correctly.
Do not remove any hydraulic components or parts
unt
il pressure has been relieved or personal injury
may occur. Do not disassemble any hydraulic
components or parts until pressure has been relieved
or
personal injury may occur. Refer to the OEM
information for any procedures that are required to
relieve the hydraulic pressure.
g00687600
Illustration 8
Always use a board or cardboard when you check
for a leak. Leaking uid that is under pressure can
penetrate body tissue. Fluid penetration can cause
serious injury and possible death. A pin hole leak can
cause severe injury. If uid is injected into your skin,
you must get treatment immediately. Seek treatment
from a doctor that is familiar with this type of injury.
Containing Fluid Spillage
NOTICE
Care must be taken to ensure that uids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the uid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing uids.
Dispose of all uids according to local regulations and
mandates.
Asbestos Information
g00702022
Illustration 9