Operation and maintenance manual

54 SEBU8601-01
Operation Section
Engine Diagnostics
Table 4
System Configuration Parameters
Configuration Parameters Record
Engine Serial Number
Delayed Eng
ine Shutdown
Factory Installed Aftertreatment #1 Identification Number
DPF #1 Soot Loading Sensing System Configuration Code
Limp Home Engine Speed Ramp Rate
System Operating Voltage Configuration
Rating Number
CAN Communication Protocol Write Security
Customer Specified Parameters
Customer specified parameters allow the engine to
be configured to the exact needs of the application.
The electronic service tool is required in order to alter
the customer configuration parameters.
Customer parameters may be changed repeatedly as
operational requirements change.
Table 5
Customer Specified Parameters
Specified Parameters Record
Thro
ttle Type Channel 1
Throttle Type Channel 2
Continuous Position Throttle Configuration 1
Continuous Position Throttle Configuration 2
Multi Position Throttle Switch Configuration
Throttle Arbitration
E
quipment ID
Low Idle Speed
Ether Solenoid Configuration
Engine Idle Shutdow n Minimum Ambient Air Temperature
Engine Idle Shutdown Maximum Ambient Air Temperature
Engine Idle S hutdown Enable Status
Engine Idle Shutdown Delay Time
Engine Idle Shutdown Ambient Temperature Override Enable Status
Delayed Engine Shutdown Maximum Time
High Soot Load Aftertreatment Protection Enable Status
Key off regen enable status
Key Off Aftertreatment Regeneration Maximum Time
(continued)