Operation and maintenance manual

SEBU8601-01 107
Maintenance Section
Engine Mounts - Inspect
g02346499
Illustration 69
Typical
example
(A) Alignment postion
(B) Alignment postion
3. Note the orientation of the filter element. Remove
the filter element (4) from the bottom cap (2).
Remov
e the seal (5).
Note: The bottom cap has a section that allows
acces
s in order to remove the seal.
4. Install a new seal (5). Install a new filter element
into t
he bottom cap (2).
5. Align position (A) on the filter element to position
(B) o
n the top cap. Refer to illustration 69.
6. Install the assembly of the filter element and the
bott
om cap (2). Rotate the bottom cap by hand
clockwise until the bottom cap locks into the
locked position on the breather body. Ensure
tha
t the alignment marks (X and Y) are correctly
aligned. Refer to illustration 68.
7. Ins
tall tube connection (1). Ensure that the
retaining clips on the tube connection are correctly
engaged. Remove the container.
Check the System
g02346500
Illustration 70
Typica l e xample
Inspect the breather tube (1) for damage. Ensure that
the outlet (2) is clean and free from any obstructions.
Ice can cause obstructions in adverse weather
conditions.
i02323089
Engine Mounts - Inspect
Note: The engine mounts may not have been
supplied by Perkins. Refer to the OEM information
for further information on the engine mounts and the
correct bolt torque.
Inspect the engine mounts for deterioration and for
correct bolt torque. Engine vibration can be caused
by the following conditions:
•
Incorrect mounting of the engine
•
Deterioration of the engine mounts
•
Loose engine mounts
Any engine mount that shows deterioration should
be replaced. Refer to the OEM information for the
recommended torques.