Installation Manual

Electrical & Electronic Application And Installation Manual
Production Release Version 1.0
Page 8
The information contained in this manual is confidential and proprietary to
Perkins. It is intended for circulation only to Perkins employees, or to
employees of OEMs intending to purchase and install Tier 4 Final/EU Stage
IV Perkins engines in their equipment. Distribution of this material must be
limited to personnel whose duties require knowledge of such material and is
intended exclusively for their information and training. Distribution of this
material for other purposes is strictly prohibited.
A&I Manual Introduction
This manual has been compiled to explain mandatory requirements, provide
information for designers, and provide information on the application and
installation of the 1204F-1206F engines into industrial equipment, to meet
U.S. Environmental Protection Agency (EPA) Tier 4 Final and European
Union (EU) Stage IV emission standards.
Serial number prefixes for the engines referenced in this manual are:
1204F : MT, MU, MW & MV
1206F : BM & BN
The following media publications for the relevant engine type should also be
used for further technical information:
• 1204F-1206F Application and Installation Manual TPD1830
• 1204F DEF System Supplement TPD1832
• 1206F DEF System Supplement TPD1834
• Operator and Maintenance Manual (OMM)
• System Operation Test and Adjust (SOTA)
• Disassembly and Assembly (D&A)
• Engine Specification Manual (ESM)
Always follow correct practices, procedures, and safety precautions.
Please note:
The information provided may be subject to change. Perkins has provided this
information in good faith and is not liable for how this information is interpreted
or applied.
Perkins is not responsible for failures resulting from attachments, systems,
accessory items, and parts not sold or approved by Perkins. Consult the
applicable warranties for complete details of the Perkins warranty coverage.
The OEM and customer are reminded that it is their responsibility to ensure
compliance with the requirements of any applicable employee health and
safety laws and regulations, both nationally and internationally, in relation to
the engine installation applicable to the equipment concerned. In giving notice
of approval in respect to the installation, Perkins does not assume such
responsibilities on behalf of the OEM or customer and while engine installation
approval and advice is an opinion given in good faith, the equipment
manufacturer and customer remain responsible as detailed above and must
act and insure accordingly.