Installation Manual

Electrical & Electronic Application And Installation Manual
Production Release Version 1.0
Page 75
Com
ponent
On AT Module
Additional Requirements
DOC Inlet
Temperature Sensor
Yes Requires Wiring Back to
Tenneco XNOx Connector By
OEM
DEF Injector Yes Requires Wiring Back to
Tenneco XNOx Connector By
OEM
SCR Inlet
Temperature Sensor
Yes Requires Wiring Back to
Tenneco XNOx Connector By
OEM
Tailpipe Ammonia
Sensor
No Requires Installation by OEM
and wiring back to the engine
ECM J1 connector
Tailpipe Outlet NOx
Sensor
No Sensor must be fitted and wired
back to ECM J1 Connector by
OEM
Engine Out NOx
Sensor
No Sensor must be fitted and wired
back to ECM J1 Connector by
OEM
Aftertreatment ID
Module
No Requires mounting on machine
and wiring back to ECM J1
connector by OEM
Table 7.4 DOC + SCR Connection Requirements
Tailpipe Out Nox Sensor
Turbo Out Nox Sensor
DOC Inlet Temperature
Sensor
Engine ECM J1 Customer
Connector
Connector – AMP 776433-2
Sockets – Deutsch 0462-201-1631
Connector – AMP 776433-1
Sockets – Deutsch 0462-201-1631
Connector – AMP 282080-1
Sockets – AMP 282110-1
SCR Inlet Temperature
Sensor
Connector – AMP 282080-1
Sockets – AMP 282110-1
Ammonia Sensor
Sockets – AMP 1-968873-2
Connector – AMP 1-1418390-1
Connector – Deutsch DRCP28-86SA
Sockets 18-16AWG – Deutsch 1062-20-0377
Sockets 12-14AWG – Deutsch 1062-12-0166
Aftertreatment ID Module
Connector – AMP 776433-3
Sockets – Deutsch 0462-201-1631
Figure 7.4 Connector Detail