Installation Manual

Electrical & Electronic Application And Installation Manual
Production Release Version 1.0
Page 65
Figure 6.3 Air Inlet Temperature Sensor
6.2.2 Ambient Air Temperature Sensor Configuration
All engines are supplied programmed with a standard 5
o
C air inlet
temperature sensor offset to calculate the local ambient air temperature being
breathed by the engine. This offset value is fixed and requires no in
application calibration. For further information on the installation requirements
for the engine air intake system please refer to the Mechanical A&I manual.
6.2.3 Ambient Air Temperature Sensor Installation
The air inlet temperature sensor should be installed within the outlet pipe from
the application air filter. The sensor must be mounted as close to the air
cleaner outlet as possible to ensure that a valid ambient air temperature
reading is taken. There are two sensor part numbers available, with the only
difference being the external thread. Both sensor part numbers are shown in
table 6.4.
Figure 6.4 Air Inlet Temperature Sensor Mating Connector
D
escription
Perkins
Part Number
Supplier Part Number
Qty
Sensor metric T407354 N/A N/A
Sensor Imperial - N/A N/A
2 Way Amp Seal 28170044 AMP 776427-1 1
Sockets 18AWG 2900A009 Deutsch 0462-201-16141 2
Table 6.4 Air Inlet Temperature Mating Connector Part Number
Please note that this sensor will form part of the standard customer J1
machine harness.