Installation Manual

Electrical & Electronic Application And Installation Manual
Production Release Version 1.0
Page 245
Requested Percent Fan
Speed **
986 1 8 bits % 0.4%/bit 0 100
TSC1 0 0 3 Rx
Engine Override Control Mode 695 1.1 2 bits States 4 states/2 bit 0 3
Engine Override Control Mode
Priority
897 1.5 2 bits States 4 states/2 bit 0 3
Engine Requested
Speed/Speed Limit
898 2-3 16 bits rpm 0.125rpm/bit 0 8031.875
Engine Requested
Torque/Torque Limit
518 4 8 bits % 1%/bit
-125% Offset
-125 125
OPERATOR INDICATORS FEFF 62579 6 Tx
Water In Fuel Indicator 97 1.1 2 bits States 4 states/2 bit 0 3
ENGINE HOURS FEE5 65253 6 On Req
Engine Total Hours Of
Operation
247 1-4 32 bits hour 0.05h/bit 0 210,554,060.7
5
ENGINE OPERATING
INFORMATION (EOI)
FD92 64914 3 Tx
Engine Operating State 3543 1.1 4 bits States 11 states/4 bit 0000 0100 & 0101
only
* Denotes those parameters that require the use of the transport protocol in the event of the data being too large for the message.
** Feature not currently available.
Diagnostic Support.
DIAGNOSTIC MESSAGES
Active Diagnostic Trouble
Codes (DM1)
FECA 65226 6
Malfunction Indicator Lamp
Status
1213 1.7 2 bits States 2 states/2 bit 0 1
Red Stop Lamp Status 623 1.5 2 bits States 2 states/2 bit 0 1
Amber Warning Lamp Status 624 1.3 2 bits States 2 states/2 bit 0 1
Protect Lamp Status 987 1.1 2 bits States 2 states/2 bit 0 1
Flash Malfunction Indicator 3038 2.7 2 bits States 4 states/2 bit 0 4
Flash Red Stop Indicator 3039 2.5 2 bits States 4 states/2 bit 0 4
Flash Amber Warning
Indicator
3040 2.3 2 bits States 4 states/2 bit 0 4
Flash Protect Indicator 3041 2.1 2 bits States 4 states/2 bit 0 4
Suspect Parameter Number* 1214 3-5.6 19 bits Status 1 SPN/bit 0 524287
Failure Mode Identifier 1215 5.1 5 bits Status 1 FMI/bit 0 31