Installation Manual

Electrical & Electronic Application And Installation Manual
Production Release Version 1.0
Page 203
Low Coolant Level Monitoring Configuration
Status
Default
Value
Time Delay (sec)
Set Points
Range
Default
Range
Defaul
t
Severity L1 On 1 to 120sec 10
N/A N/A Severity L2 On 1 to 120sec 10
Severity L3 Off 1 to 120sec 10
Table 15.6 Low Coolant Level Monitoring Mode Operation Configuration
15.2.3 Coolant Level Switch Installation
Figure 15.3 Coolant Level Switch T400042
To ensure the correct operation of the engine monitoring system for the
coolant level switch the Perkins approved part shown in table 15.7 must be
used. Table 15.7 also provides the part numbers required to connect to the
coolant level switch.
REQ
UIRED PARTS
Perkins
Part
Number
Supplier Part Number
Description
Qty
T400042 N/A Coolant Level Switch 1
28170056 N/A Connector Plug Kit 1
N/A Deutsch DT06-3S-EP06 Plug 1
N/A Deutsch W3S-P012 Wedge Lock 1
2900A016 Deutsch 0462-201-1631 Connector Socket
(Gold)
3
Table 15.7 Coolant level switch Installation Parts List
The coolant level switch is a three wire switch which requires connection to
the ECM J1 8V sensor supply and ground pins as shown in figure 15.4
Figure 15.4 Coolant Level Switch Installation Wiring
15.3 Auxiliary Temperature Sensor
15.3.1 Auxiliary Temperature Sensor Operation
The auxiliary temperature sensor feature is provided so the engine can
monitor any external temperature and provide that temperature information on
the J1939 CAN data link. The ECM can also protect the system from
excessive temperature by raising the severity levels as configured within the
engine monitoring system as shown in table 15.8. As with all engine
monitoring system parameters the engine ECM will raise an event code once
a severity level threshold is exceeded.