Installation Manual

Electrical & Electronic Application And Installation Manual
Production Release Version 1.0
Page 180
The Engine wait To Start Indicator is also available via J1939 as shown
below.
Function
PGN
SPN / Byte
Start bit
Length
Applicable
States
Warning
Indicator Status
FEE4 1081 / 4 1 2 00 (OFF)
01 (ON)
13.3.7 Oil Pressure Indicator
13.3.7.1 Oil Pressure Indicator Operation
The low engine oil pressure lamp is used in conjunction with the engine
monitoring system to indicate to the operator that the engine oil pressure has
dropped below a predefined threshold. Details of the threshold levels are
given in section 14 of this document. The lamp will illuminate once this
threshold is exceeded and remain on until the pressure has stabilized again
above the threshold level.
13.3.7.2 Oil Pressure Indicator Configuration
The Threshold level for the lamp activation are set within the engine software
and are non-configurable. There is no configuration required for the Oil
Pressure Indicator to operate.
13.3.7.3 Oil Pressure Indicator Installation
No specific Low Oil Pressure Indicator is provided by Perkins onto the J1939
CAN bus. Specific engine event codes which operate the engine warning
indicator and the shutdown indicator are supported please see section 14 for
more details.
13.3.8 Emissions System Malfunction Indicator
13.3.8.1 Emissions System Malfunction Indicator Operation
The emissions system malfunction indicator is designed to highlight any faults
with emissions system critical components. This indicator is used along with
the engine shutdown indicator to highlight EGR system and SCR system
failures. The indicator is mandatory and its use is governed by the EU and