Installation Manual

Electrical & Electronic Application And Installation Manual
Production Release Version 1.0
Page 179
13.3.5.1 Engine Warning Indicator Operation
The Warning lamp is used to alert the operator of an engine operating
condition that has the potential to cause engine damage. The lamp will
illuminate when an active diagnostic or event code is raised. The warning
lamp will flash for any diagnostics that cause an engine derate or any event
code with a severity level 2 or greater.
13.3.5.2 Engine Warning Indicator Configuration
The engine warning lamp is a mandatory fit item. There is no specific
configuration necessary for the Engine warning Indicator.
13.3.5.3 Engine Warning Indicator Installation
The Engine warning Indicator is also available via J1939 as shown below.
Function
PGN
SPN / Byte
Start bit
Length
Applicable
States
Warning
Indicator Status
FECA 624 / 1 3 2 00 (OFF)
01 (ON)
Warning
Indicator Flash
FECA 3040 / 2 3 2 00 (Slow
Flash
01 (Fast
Flash)
11 (Do Not
flash)
13.3.6 Engine Wait To Start Indicator
13.3.6.1 Engine Wait to Start Indicator Operation
The Wait To Start Indicator is a mandatory component, which is used to
indicate to the operator that the engine is ready to start. The Indicator is
controlled by the engine cold start strategy and while illuminated indicates that
the engine should not be started. For more information on the wait to start
indicator operation please refer to section 11 glow plug operation.
13.3.6.2 Engine Wait To Start Indicator Configuration
No specific Indicator configuration is required for this feature.
13.3.6.3 Engine Wait To Start Indicator Installation