Operation and maintenance manual

SEBU7833-03 5
Safety Section
Safety Messages
Safety Section
i03299360
Safety Me ssage s
There may be s
everal specific warning signs on
an engine. The exact location of the hazards and
the description of the hazards are reviewed in this
section. Ple
ase become familiar with all warning
signs.
Ensure that a
ll of the warning signs are legible. Clean
the warning signs or replace the warning signs if
the words cannot be read or if the pictures are not
visible. Wh
en the warning signs are cleaned, use a
cloth, water, and soap. Do not use solvent, gasoline,
or other harsh chemicals to clean the warning signs.
Solvents,
gasoline, or harsh chemicals could loosen
the adhesive that secures the warning signs. The
warning signs that are loosened could drop off of
the engine
.
Replace any damaged warning signs or missing
warning si
gns. If a warning sign is attached to a part
of the engine that is replaced, install a new warning
sign on the replacement part. Perkins dealers or
Perkins d
istributors can provide new warning signs.
Do not work on the engine and do not operate the
engine un
less the instructions and warnings in the
Operation and Maintenance Manual are understood.
Correct care is your responsibility. Failure to follow
the inst
ructions or failure to heed the warnings could
result in injury or in death.
(1) Universal Warning
Do not operate or work on this equipment unless
you hav
e read and understand the instructions
and warnings in the Operation and Maintenance
Manuals. Failure to follow the instructions or
heed th
e warnings could result in serious injury
or death.
g01154807
Illustration 1
Typical example
The Universal Warning label (1) may be located on
the valve mechanism cover or the inlet manifold.
Refer to illustration 2.
Note: The location of this label will depend on the
application of the engine.
g01682734
Illustration 2
Typical example
(2) Ether
Do not use aerosol types of starting aids s uch as
ether. Such use could result in an explosion and
personal injury.