Troubleshooting

66 RENR2696-01
Troubleshooting Section
Results:
•
OK – STOP.
i01798144
CID 0091 FMI 08 Thro ttle
Demand Sensor Abnormal
Signal
Conditions Which Generate This Code:
The ECM is not r
eceiving a correct throttle position
signal.
System Respon
se:
The ECM will log the diagnostic code. The diagnostic
code may be vi
ewed on the electronic service tool.
The ECM returns the engine to low idle or a safe
speed when th
e problem is detected. The diagnostic
code is logged only if the engine is running. The
electronic service tool will indicate DIAG and a throttle
position of
0 percent while the diagnostic code is
active. This will happen regardless of the position of
the throttle pedal assembly. The engine will remain at
low idle or a
t the safe speed while the code is active.
Troubleshooting:
The diagnostic code is likely to be caused by one of
the following conditions:
•
Open circuit for the throttle position sensor
•
Open circu
it for the voltage supply
Perform the following diagnostic procedure: “Throttle
Position S
ensor Circuit - Test”
Results:
•
OK – STOP.
i01798145
CID 0091 FMI 12 Thro ttle
Demand Sensor Out Of
Calibrati
on
Conditions Which Generate This Code:
The ECM det
ects the following conditions:
•
A 5 volt failure
•
A5voltfault
System Respons
e:
The ECM will log the diagnostic code. The diagnostic
code may be vie
wed on the electronic service tool.
TheECMwillreturntheenginetothelowidleorto
the predeterm
ined safe speed while the diagnostic
code remains active.
Possible Perf
ormance Effect:
•
Low power
•
Reduced engine speed
Troubleshoot
ing:
Perform the following diagnostic procedure: “Throttle
Position Sen
sor Circuit - Test”
Results:
•
OK – STOP.
i01798146
CID 0100 FMI 03 Engine Oil
Pressure Senso r Open Circui t
Or Shorted Hi
gh
Conditions Which G enerate This Code:
The ECM dete
cts all of the following conditions:
•
Signal voltage is above normal.
•
The ECM has been powered for at least 15
seconds.
•
CID 262-03 5V Sensor Power Supply, Voltage
More Than Normal and CID 262-04 5V Sensor
Power Suppl
y, Voltage Less Than Normal are not
active.
System Resp
onse:
The ECM will set the engine oil pressure to a default
value.
The electronic service tool will display “Open/Short
High” for t
he engine oil pressure on the status screen.