Troubleshooting

16 RENR2696-01
Troubleshooting Section
Use the lamps to
check the engine’s
operational status or the existence
of any engine faults.
Each lamp will
be illuminated in a combination of
ways in order to identify the engine’s operational
status. The lamps will also be illuminated in a
combination
of ways to indicate if the engine has a
fault. These combinations of illuminated lamps have
the following meanings:
The status of the lamps before the engine is
cranked. This also acts as a lamp check.
When the ignition switch is turned ON, the lamps will
be illuminated for 2 seconds. The lamps are then
OFF unless t
he cold starting aid is required.
Table 4
Orange
lamp
(status)
Red lamp
(status)
Comments
ON ON
The lamps will be illuminated
for 2 seconds or the lamps
will be illuminated until the
engine is cranked.
Refer t o the
comments.
OFF ThelampwillbeOFFunless
thecoldstartingaidis
required.
The lamp status with the cold starting aid in
operation and before the engine is cranked.
The orange lamp will be illuminated until the engine
is ready to be cranked.
Table 5
Orange
lamp
(status)
Red lamp
(status)
Comments
ON OFF The status of the lamps
withthecoldstartingaidstill
operating.
Then OFF OFF This is the status of the
lamps while the engine is
being cranked. The cold
starting aid is no longer
operating.
This is the status of the lamps while the engine
is being cranked.
Unless there is a fault, the engine monitoring system
will not illuminate the indicator lamps while the
engine is being cranked. For example if there is a
lack of lubricating oil pressure after the start delay is
exceeded. This type of fault will cause the stop lamp
for the engine to be illuminated.
Table 6
Orange
lamp
(status)
Red lamp
(status)
Comments
OFF OFF
There are no apparent
problems.
ON ON
The lubricating oil pressure
is low. This low oil pressure
was measured after the set
delay had expired.
The status of the lamps after cranking has failed
to start the engine .
Table 7
Orange
lamp
(s
tatus)
Red lamp
(status)
Comments
OFF OFF No faults were detected.
ON OFF An electrical fault was
detected.
OFF
Flashing The engine was activated
when a serious fault was
detected.
Other combinations of illuminated indicator lamp
The following combinations of lamp status may also
be exhibited when the engine is either running or
when the engine has been shut down automatically.