Troubleshooting

RENR2696-01 15
Troubleshooting Section
(Table 3, contd
)
1684 02 J1077 02 Fuel Injection Pump, software failure
1684 03 J1077 03
Fuel Injection Pump, fuelling fault
1684 04 J1077 04
Fuel Injection Pump, supply voltage fault
1684 05 J1077 05 Fuel Injection Pump, invalid pulse width
1684 07 J1077 07
Fuel Injection Pump, mechanical fault
1684 08 J1077 08
Fuel Injection Pump, crankshaft reference fault
1684 09 J1077 09
Fuel Injection Pump, CAN fault
1684 10 J1077 10
Fuel Injection Pump, fuel shutoff signal error
1684 11 J1077 11
Fuel Injection Pump, internal sensor fault
1684 12 J1077 12
Fuel Injection Pump, device failure
1684 14 J1077 14 Fuel Injection Pump, no communications
1690 08
Analogue Speed Control, signal abnormal
1743 02
Engine Mode Selection Switch State, invalid state
1894 02
Set Speed Control D isengage Switch, invalid state
1895 02
Set Speed Control Speed Toggle Switch, invalid state
Event Cod
e
CID FMI Co
de
E015 110 16 High Engine Coolant Temperature Derate
E016 110 00 High Engine Coolant Temperature Sutdown
E017 110 15 High Engine Coolant Temperature Warning
E025 105 16 High Intake Air Temperature Derate
E027 105 15 High Intake Air Temperature Warning
E039 100 18
Low Eng
ine Oil Pressure Derate
E040 100 01 Low Engine Oil Pressure Shutdown
E054 174 16 High Fuel Temperature Derate
E056 174 15 High Fuel Temperature Warning
E100 100 17
Low Engine Oil Pressure Warning
E190 190 15
Engine Overspeed Warning
E442
Engi
ne Failed To Stop With A No-Fuel C ommand
E883 Engine Failed To Stop When Fuel Solenoid Disengaged
i01878735
Indic ator Lamps
Some engine applications are equipped with Indicator
Lamps. Indicator lamps can be used as a diagnostic
aid. There are two lamps. One lamp has an orange
lens and the other lamp has a red lens.
These indicator lamps can be used in two ways:
•
The indicator lamps can be used to identify the
current operational status of the engine. The
indicator lamps can also be used to indicate that
the engine has a fault. This system is automatically
operated via the ignition switch.
•
The indicator lamps can be used to identify active
diagnostic codes. This system is activated by
pressing the Flash Code button.