Specifications

UnPacking The RM2000______ Compatibility______________
Included in the shipping carton you should The ReceiptMaster 2000 is completely
find: compatible with the VeriFone Printer 250.
• This Instruction Sheet However, each terminal requires its own
• Receipt Master 2000 Printer unique cable connections. If you have
• Power Supply difficulty connecting your cable, due to
• Data Cable different pin outs, contact your help desk.
Connecting The Cables_______ Paper Installation__________
The RM2000 has two connectors on the back The RM2000 utilizes high-quality thermal
back of the unit, an 8 pin miniDIN serial port paper.
(left side, as viewed from the back, see figure 1)
and power supply port (right side as viewed Loading Paper(see figure 2):
from the back, see figure 1). 1. Open cover.
2. Feed edge of paper into slot.
Connecting the power supply: 3. Press the FEED button to pull paper
1. Insert the miniDIN end of the cable into the through.
miniDIN connector (left port) at the back 4. Place paper roll into printer.
of the RM2000. 5. Close cover.
2. Plug the other end of the cable into your 6. Tear off excess.
your terminal’s serial port.
Connecting the power supply:
1. Plug the power pack into a standard 110-
120 Volt outlet.
2. Plug the opposite end of the power pack
into the part (right side) at the back of the
RM2000.
3. Indicator light should be steady on.
Paper Removal:
1. Cut or tear paper at the base of the paper
roll.
2. Press the FEED (right) button until the
remaining paper has passed through the
printer.
2
Set Up__ _____________ Useful Hints_______________
Printer Configuration: Indicator Light:
The RM2000 prints a menu to guide you • Steady On indicates that the printer has
through the set up options which allows you power and paper and is ready to print.
to change communication and copy options. • Continuous flashing indicates a fault
condition, usually out of paper.
To Enter This Mode: • When in the printer configuration mode,
1. Simultaneously, press and hold the CLEAR a momentary flash confirms that a button
and FEED buttons and plug printer into the was pushed.
power source.
2. Release both buttons.
3. The printer configuration menu will be
Operation_________________
printed.
4. To change the printer’s configuration follow There are two buttons on the front of the
the printed instructions. printer. The function performed by these
5. At any time during configuration Set Up, buttons depends on the mode of the printer,
You can exit and save by pressing the as described in table 1.
CLEAR and FEED buttons simultaneously
and releasing.
Self-Test___________________
The Self-Test displays the current option
settings and a checkered pattern showing that
the print head is functioning properly (see
figure 3).
To Enter This Mode:
1. Press and hold the FEED button. Receipts:
2. Plug the printer into the power source. Print the first copy of a receipt as you
3. Release the FEED button. normally would, either by running a
transaction or by requesting a reprint of a
previous transaction. After the first copy
is printed a second copy will be printed
automatically depending on the options
chosen in the printer configuration.
Maintenance______________
Under normal operating conditions, your
RM2000 printer should be maintainence-
free. Should print quality suffer due to
build up of contaminants on the print
head, a head cleaning kit is available from
your help desk.
3