Installation Guide

0180_Jan20_5in1 P.2
1 EXPANSION PROFILE/T-MOLDING
First cut the prole to the correct length.
Use the slitter to cut away piece A and
piece B to obtain an expansion prole/
Tmolding. Note: for easy cutting, cut both
lengths before removing the 2 pieces of
HDF. While installing the oor, be sure
to allow sucient space between the
two surfaces that will be joined with the
prole. Remember to take into account
the expansion gap between the raised
legs of the rail (in which the prole will be
inserted) and the oor. Cut the plastic rail
to the correct length and place it in the
middle of the open area between the two
oor surfaces. The rail can be attached
in several ways, see below. Gently press
from one side of the rail to the other.
Press against the oor.
2 ADAPTOR PROFILE/HARD
SURFACE REDUCER
First cut the prole to the correct length.
Use the slitter to cut away piece A to
obtain an adaptor prole/reducer. Mark
the ground to indicate how far the
edge of the oor will extend. Allow the
underlayment to extend to just before
this line; it is better to t the rail (in
which the adaptor prole/reducer will
be clamped) later on top of the suboor.
There must be a sucient expansion
gap between the raised legs of the rail
(in which the prole will be clamped)
and the oor. Attach the plastic rail to
the suboor with the long lip in the oor
direction. Installation details: see below.
Gently press from one side of the rail to
the other. Press against the oor.
5 IN 1 Multi-Functional Molding | English