Installation Guide

0180_Jan20_5in1 P.1
5 In 1 Multi-Functional Molding
Installation Instructions
5 IN 1 Multi-Functional Molding | English
The 5 in 1 molding oers an easy solution for the perfect nishing of your oor. You can use
the prole in 5 ways: 1) as an expansion prole/T-molding, 2) an adaptor prole/hard surface
reducer, 3) an end prole/square nose, 4) a carpet transition strip and 5) to nish o your stairs.
WHY AN EXPANSION GAP?
This oor is primarily made of wood. Because the humidity level in the room can vary, for
example between summer and winter, it is necessary that the oor has room to expand and
contract along all sides. This is why an expansion gap is needed around the perimeter of the
oor.
INSTRUCTIONS FOR USE SLITTER
CAUTION: Always wear gloves - the edge of the prole and the blade are sharp. Read the
instructions carefully before use.
1. The slitter can be used to cut away one or two pieces of the prole to obtain a
T-molding, hard surface reducer, end prole, or carpet transition.
2. When cutting the prole, always lay it horizontally on a stable surface.
3. Place the cutting tool on top of the prole, so that the blade underneath ts
into the narrow slit in the prole.
4. Press down on the cutting tool and slide it gently in the direction of the arrow.
5. Take o the piece to be removed. Remove any unevenness on the edge of the
prole by again moving the side of the slitter (sandpaper) along the prole.

Summary of content (12 pages)