Use And Care Manual

CAUTION: Certain cleaning agents and solvents damage plastic parts. Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents, ammonia and household detergents that contain ammonia. Avoiding use of
these and other types of cleaning agents minimizes the probability of damage. To avoid shock or re hazard, if the power
cord is worn, cut or damaged in any way, have it replaced immediately.
WARNING: To reduce the risk of injury, turn power switch off and remove plug from the power source outlet
before doing maintenance on or lubricating your drill press.
WARNING: All repairs, electrical or mechanical, should be attempted only by trained technicians. Use only identical
replacement parts; any other may create a hazard.
Page 26
Frequently blow out or vacuum sawdust or metal chips that accumulate in and on the motor, pulley housing, table and
work surface.
A coat of furniture-type paste wax applied to the table, column, and machined parts of the base will help to keep these
surface clean.
The ball bearings in the spindle and the V-belt pulley assembly are greased and permanuntly sealed. Pull the spindle down
and oil the spindle sleeve moderately every three months.
MAINTENANCE
GENERAL MAINTENANCE