Manualshelf

Use And Care Manual

ManualsBrandsPerformax ManualsDrill Presses10" 5-Speed Bench Drill Press
21222324252627282930
CAUTION: DO NOT OPERATE drill press until it has been assembled and installed. Read and follow all safety
rules within this Instruction Manual, failure to do may result in electric shock and/or serious personal injury.
CAUTION: ALWAYS REMOVE CHUCK KEY before connecting tool to power source.
Page 21
WARNING: RISK OF PERSONAL INJURY. NEVER PERFORM ANY DRILLING OPERATION FREEHAND (WITHOUT
WORKPIECE AGAINST THE TABLE). The bit could grab the workpiece if it slips or twists.
WARNING: RISK OF PERSONAL INJURY. ALWAYS DISCONNECT THE TOOL FROM THE POWER OUTLET
BEFORE MAKING ANY ADJUSTMENT, INSTALLING OR CHANGING BITS OR OTHER TOOLS.
A
A
B
FIG. 19
OPERATION
ON/OFF SWITCH (Fig. 19)
Drill press is equipped with an ON/OFF switch key. Removal
of the safe key prevents the drill from being turned ON.
Remove the key to avoid unintentional start up or
unauthorized use of the drill.
• To turn the drill press on, insert the safety key (A) into the
switch housing and move the ON/OFF (B) switch to the
ON position.
• To turn the drill press off, move the switch to the OFF
position.
• To lock the switch in the off position, remove the safety
key from the switch. Store the key in a safe place.
FIG. 20
LED LIGHT SWITCH (Fig. 20)
The LED light switch (A) is located on the side of the LED
light.
• Press the LED light switch to turn the LED light on.
• Press the LED light switch again to turn the LED light off.
WARNING: CHEMICAL HAZARD. FOLLOW ALL RECOMENDED SAFETY PRECAUTIONS WHILE OPERATING
THE DRILL PRESS. Some dust created by power sanding, grinding, drilling, and other construction activities contains
chemicals known to cause cancer, birth defects or other reproductive harm. Your risk from these exposures varies, depending
on how often you do this type of work. To avoid risk from exposure to these chemicals the following safety measures are
required during operation of this tool: Work in a well ventilated area and work with approved safety equipment, such as
those dust masks that are specially designed to lter out microscopic particles.