Use And Care Manual

Page 15

ASSEMBLY

CAUTION: One or two of the feed handles may be

removed if an unusually-shaped workpiece interferes with

handle rotation.

CAUTION: If the stand or workbench has a tendency

to move during operation, fasten it securely to the oor.

FIG. 4

FIG. 5

DRILL PRESS HEAD TO COLUMN (Fig. 4)

• Lift the drill press head assembly (A) carefully and place

the mounting hole of the drill press head onto the top of

the column (B). Make sure the head is seated properly on

the column.

• Align the direction of the drill press head with the direction

of the base and table.

• Tighten the two set screws (C) using the 4mm hex key.

FEED HANDLES (Fig. 5)

• Thread the three feed handle rods (A) into the holes on

the feed hub (B).

• Hand tighten.

FIG. 6

MOUNTING THE DRILL PRESS (Fig. 6)

Your drill press must be securely fastened through the

mounting holes (A) to a stand or workbench with heavy-duty

fasteners. This will prevent the drill press from tipping over,

sliding or walking during operation.