Use And Care Manual

Page 9
SAFETY INSTRUCTIONS
• Feed Handle: Moves the chuck up or down. One or two
of the handles may be removed if necessary whenever the
workpiece is of such unusual shape that it interferes with
the handles.
• Drill Bit: Cutting tools used to create cylindrical holes.
• ON/OFF Switch: The ON/OFF switch located on the front
of the drill press allows the operator to turn ON/OFF the
drill press easily. To lock the switch in the OFF position,
remove the safety key from the switch. Place the safety
key in a location that is not accessible to children and
others who are not qualied to use the tool.
• Pulley: Spindle or motor mounted wheel with groves along
its edge to accept a drive belt for the purpose of control
speed.
• Quill: Feed tube used to control vertical movement of the
spindle.
• Spindle Speed: Five different spindle speeds allow you
to drill a wide variety of material including wood, plastic
and metal.
• Spindle: Shaft rotating on a vertical axis in which the
chuck is attached.
• Workpiece: The item which the cutting operation is being
applied too.
• Backup Material: A piece of scrap wood placed between
the workpiece and table. The backup board prevents wood
in the workpiece from splintering when the drill passes
through the backside of the workpiece. It also prevents
drilling into the table top.
• Motor: Your drill press is equipped with an industrial-duty
induction motor for long-lasting, smooth performance.
• LED Worklight: Unique LED worklight illuminates work
surface under low light conditions. The worklight turns on
with the LED worklight switch.
• Laser Guide: For more accurate cuts, a laser guide is
included with your Drill Press. When used properly, the
laser guide makes accurate, precision cutting simple and
easy.