Use And Care Manual

9
CONNECTING THE TOOL
1. After reading and understanding this entire manual, connect tool to the air
supply.
2. Turn the compressor on and set the regulator to proper pressure for the size
and type of fasteners being used.
CAUTION:
Keep the tool pointed away from yourself and others at all times.
Do not load fasteners with trigger or safety pressed.
Always wear approved safety glasses and hearing protection when
preparing or operating this tool.
Never use a tool that leaks air or needs repair.
CAUTION:
All air line components (including hoses, pipe, connectors, filters,
& regulators, etc.) must be rated for a minimum working pressure
of 150 PSI or 150% of the maximum system pressure, whichever is
greater.
Disconnect the tool from the air supply before performing
maintenance, clearing a jammed fastener, leaving the work area,
moving the tool to another location, or handing it to another person.
9
Air fitting: The nailer is equipped with a ¼” NPT male industrial style plug.The
plug can be connected to a ¼”Universal style female coupler.To prevent
accidental firing,the air supply connection must not hold pressure when air
supply is disconnected. If an incorrect fitting is used, the tool can remain
charged with air after disconnecting and thus will be able to drive a fastener
even after the air line is disconnected, possibly causing injury.