Use And Care Manual

8
All compressed air contains moisture and other
contaminants that can harm the internal
components of the tool. An air line filter will
remove most of these and significantly extend
the life of the tool. Ensure the in-line oiler has
sufficient oil. If an in-line oiler is not available,
place 2 drops of oil into the tool’s air inlet at
the beginning of each workday. More than
this will be expelled from the tool’s exhaust
during firing.
Fig.3
FUNCTIONAL DESCRIPTION
Fig.1
A
J
F
B
E
H
K
D
G
C
I
L
OPERATING PROCEDURES
SET UP AIR SOURCE
The PERFORMAX 2 in 1 nailer/stapler is designed to operate on clean, dry,
compressed air, regulated at 70-110 PSI. The preferred system would
include a filter, a pressure regulator, and an automatic oiler located as close
to the tool as possible. Within 15 feet (5 m) is ideal. Do not use bottled air or
gases. Please see below:
2 in 1 nailer/stapler
Fig.2
Figure 1 names the major components
of the PERFORMAX 2 in 1 nailer/stapler:
A. Exhaust Deflector
B. Body
C. Quick Release Lever
D. Magazine
E. Magazine Latch
F. 1/4” NPT Air Plug
G. Depth Adjustment Konb
H. Trigger
I. No-Mar Tip
J. Top Cap
K. Hand Grip
L. Safety