Use And Care Manual

7
Use only a pressure-regulated compressed air source to limit the air pressure
supplied to the tool. The regulated pressure must not exceed 110 PSI. If the
regulator fails, the pressure delivered to the tool must not exceed 120 PSI.
The tool could explode which will cause death or serious personal injury.
Always disconnect air resource:
a) Before making adjustments.
b) When servicing the tool.
c) When clearing a jam.
d) When tool is not in use.
e) When moving to a different work area, as accidental actuation may occur,
causing injury.
Never connect tool to an air source that may exceed 180 PSI. Over
pressurizing the tool may result in bursting, abnormal operation, breakage of
the tool or serious injury to persons. Use only clean, dry, regulated
compressed air at the rated pressure or within the rated pressure range as
marked on the tool. Always verify prior to using the tool that the air source
has been adjusted to the rated air pressure or within the rated air-pressure
range.
IMPORTANT SAFETY INSTRUCTIONS
Do not use any type of reactive gases, including, but not limited to, oxygen
carbon dioxide and combustible gases, as a power source. Use filtered,
lubricated, regulated compressed air only. Use of a reactive gas instead of
compressed air may cause the tool to explode which will cause death or
serious personal injury.
CARTON CONTENTS
A B
The following items are to be provided in the shipping box:
A. 2 hex keys
B. Small bottle of air tool oil