Use And Care Manual

CAUTION:
Keep the tool pointed in a safe direction at all times.
Never attempt to drive fasteners into materials too hard to
penetrate, at too steep an angle, or too near the edge of the
workpiece.
The fastener can ricochet causing personal injury.
Disconnect tool from air supply before doing any disassembly,
maintenance, clearing a jammed fastener.
Disconnect tool from air supply when leaving the work area,
moving the tool to another location, or handing the tool to another
person.
Do not use the tool unless both the trigger and the safety
mechanism are functional, or if the tool is leaking air or needs any
other repair.
Carefully check for proper operation of trigger and safety
mechanism.
Clean and inspect the tool daily.
1. Make sure the air compressor is set correctly.
2. Hold the body ( Fig.1, page 8, B ) and press safety ( Fig.1, L ) against the
work surface, the safety will now engage. Ensure the tool is perpendicular
to the surface.
3. Hold the hand grip firmly ( Fig.1, K ) and gently squeeze the trigger ( Fig.1,
H ) to drive the fastener.
4. Lift the tool off the work surface.
BASIC OPERATION
OPERATING THE TOOL
11
upward
downward
Fig.8
G
OPERATING PROCEDURES
ADJUSTING THE AIR PRESSURE
The depth to which a fastener is driven is determined by the air pressure and
the depth adjustment (Fig.8).